VESTEL B2B Support Portal | VSIGN TV SOC CLIENT INSTALLATION GUIDE

VSIGN TV SOC CLIENT INSTALLATION GUIDE

VSign TV Client Installation Guide

Requirements

Be sure about TV sw profile options are the same as below:

  • HotelTv Hotel Mode : Enabled
  • B2B Product: SignageTV
  • Welcome screen : Disabled
  • Secure Command : Disable
  • UARTRXDisableOnFTI : Disable

Note: Also be sure about there’s no TV source in the source selection menu and Service Menu>Diagnostic>Uart Rx is Enabled.

Note: Also be sure about CMS option is selected on Menu>Settings>Signage>Power Up Setting>Auto Launch

Installation

Prepare a USB stick with Vsign TV SoC Client. USB stick must have minimum 8GB capacity.

  • Unzip given application at the root of the USB 
  • Be sured about folder structure

-/mnt/hd0a/
    -vsign/
       -offline/
       -vibolib/
       -source/
       -pythonarm/
       -wstelnet/
       -config.json
       -vibo.py
       -tvlist.py
       -wss.py
       -init.sh

Put USB stick with Vsign application to TV. After rebooting, Vsign starts with opening screen. When installation is done, Vsign starts automatically after every restart or reboot. First time configuration of the Vsign TV SoC Client will be covered in VSign TV SoC Client User Guide

Uninstallation

To be able to end functionality of Vsign Player on TV, you can either unmount the USB stick or format the USB from Signage Settings. After the the reboot, TV doesn’t start with Vsign.

Updates

PROFILE UPDATE
First, make directory named profile on the root of the usb stick. Then inside this directory , put the profile file. The profile file should be made in a program named ProfileComposer.exe.
The settings in the profile has to be prepared according to the Installation Guide Requirenments.


TV SOFTWARE UPDATE
Update file should be in the root of the usb stick and name would be « upgrade_mb120.bin ».